-
Cover treadles with carpeting or other floor covering materials, and test systems by operating treadles.
-
Study blueprints and schematic diagrams to determine appropriate methods of installing or repairing automated door openers.
-
Prepare doors for hardware installation, such as drilling holes to install locks.
-
Order replacement springs, sections, or slats.
-
Lubricate door closer oil chambers, and pack spindles with leather washers.
-
Collect payment upon job completion.
-
Fasten angle iron back-hangers to ceilings and tracks, using fasteners or welding equipment.
-
Remove or disassemble defective automatic mechanical door closers, using hand tools.
-
Inspect job sites, assessing headroom, side room, or other conditions to determine appropriateness of door for a given location.
-
Install door frames, rails, steel rolling curtains, electronic-eye mechanisms, or electric door openers and closers, using power tools, hand tools, and electronic test equipment.
-
Carry springs to tops of doors, using ladders or scaffolding, and attach springs to tracks to install spring systems.
-
Fabricate replacements for worn or broken parts, using welders, lathes, drill presses, or shaping or milling machines.
-
Repair or replace worn or broken door parts, using hand tools.
-
Complete required paperwork, such as work orders, according to services performed or required.
-
Set in and secure floor treadles for door-activating mechanisms, and connect power packs and electrical panelboards to treadles.
-
Assemble and fasten tracks to structures or bucks, using impact wrenches or welding equipment.
-
Set doors into place or stack hardware sections into openings after rail or track installation.
-
Cut door stops or angle irons to fit openings.
-
Adjust doors to open or close with the correct amount of effort, or make simple adjustments to electric openers.
-
Wind large springs with upward motion of arm.
-
Operate lifts, winches, or chain falls to move heavy curtain doors.
-
Bore or cut holes in flooring as required for installation, using hand or power tools.
-
Install dock seals, bumpers, or shelters.
-
Clean door closer parts, using caustic soda, rotary brushes, or grinding wheels.
-
Run low voltage wiring on ceiling surfaces, using insulated staples.