Will “Slip Injector and Applicator” be Replaced By Robots? 🤔

88% Chance of Automation

“Slip Injector and Applicator” will probably be replaced by robots.

This job is ranked #512 out of #702. A higher ranking (i.e., a lower number) means the job is less likely to be replaced.

Care to share? Click for Facebook, Twitter, LinkedIn, or XING. 👍

Job Description

Perform tasks involving physical labor at construction sites. May operate hand and power tools of all types: air hammers, earth tampers, cement mixers, small mechanical hoists, surveying and measuring equipment, and a variety of other equipment and instruments. May clean and prepare sites, dig trenches, set braces to support the sides of excavations, erect scaffolding, and clean up rubble, debris and other waste materials. May assist other craft workers.

Job Details

The SOC (Standard Occupational Classification) code is 47-2061.00
The Mean Annual Wage in the U.S. is $ 37,890.00
The Mean Hourly Wage is $ 18.00
Currently, there are 912,100 people on this job

☝️ Information based on the reference occupation “Construction Laborers”.

Also Known As…

Tasks for “Slip Injector and Applicator”

Transport or set explosives for tunnel, shaft, or road construction.
Lubricate, clean, or repair machinery, equipment, or tools.
Mop, brush, or spread paints, cleaning solutions, or other compounds over surfaces to clean them or to provide protection.
Grind, scrape, sand, or polish surfaces, such as concrete, marble, terrazzo, or wood flooring, using abrasive tools or machines.
Use computers or other input devices to control robotic pipe cutters or cleaners.
Place, consolidate, or protect case-in-place concrete or masonry structures.
Smooth or finish freshly poured cement or concrete, using floats, trowels, screeds, or powered cement finishing tools.
Mix, pour, or spread concrete, using portable cement mixers.
Position, join, align, or seal structural components, such as concrete wall sections or pipes.
Apply caulking compounds by hand or caulking guns to protect against entry of water or air.
Measure, mark, or record openings or distances to layout areas where construction work will be performed.
Dig ditches or trenches, backfill excavations, or compact and level earth to grade specifications, using picks, shovels, pneumatic tampers, or rakes.
Mix ingredients to create compounds for covering or cleaning surfaces.
Provide assistance to craft workers, such as carpenters, plasterers, or masons.
Tend machines that pump concrete, grout, cement, sand, plaster, or stucco through spray guns for application to ceilings or walls.
Clean or prepare construction sites to eliminate possible hazards.
Operate jackhammers or drills to break up concrete or pavement.
Signal equipment operators to facilitate alignment, movement, or adjustment of machinery, equipment, or materials.
Operate or maintain air monitoring or other sampling devices in confined or hazardous environments.
Position or dismantle forms for pouring concrete, using saws, hammers, nails, or bolts.
Read plans, instructions, or specifications to determine work activities.
Tend pumps, compressors, or generators to provide power for tools, machinery, or equipment or to heat or move materials, such as asphalt.
Apply weather-stripping to reduce energy loss.
Erect or dismantle scaffolding, shoring, braces, traffic barricades, ramps, or other temporary structures.
Perform building weatherization tasks, such as repairing windows, adding insulation, or applying weather-stripping materials.
Raze buildings or salvage useful materials.
Spray materials, such as water, sand, steam, vinyl, paint, or stucco, through hoses to clean, coat, or seal surfaces.
Perform site activities required of green certified construction practices, such as implementing waste management procedures, identifying materials for reuse, or installing erosion or sedimentation control mechanisms.
Perform construction laborer duties at green building sites, such as renewable energy plants or wind turbine installations.
Install sewer, water, or storm drain pipes, using pipe-laying machinery or laser guidance equipment.
Load, unload, or identify building materials, machinery, or tools, distributing them to the appropriate locations, according to project plans or specifications.
Control traffic passing near, in, or around work zones.
Identify, pack, or transport hazardous or radioactive materials.

Related Technology & Tools

Suction sweepers
Saber saws
Motor graders
Reciprocating saws
Masonry forklifts
Impact hammers
Air compressors
Jackhammers
Mud jacks
Water samplers
Measuring wheels
Mortar mixers
Asphalt saws
Surveying rods
Plaster mixers
Mowing equipment
Crawler shovels
Winches
Jet trucks for cleaning sewer lines
Floor sanders
Brick carrier forks
Swing chairs
Trowels
Two way radios
Brick hammers
Oxygen/acetylene torches
Tampers
Bosun chairs
Spirit levels
Shovels
Nail guns
Walk-behind saws
Adjustable widemouth pliers
Temperature probes
Fencing pliers
Mortar hoes
Hoists
Robotic pipe cleaners
Concrete saws
Crowbars
Generators
Pneumatic staplers
Axes
Hydraulic chainsaws
Power buggies
Laser screeds
Pedestal grinders
Calipers
Sandblasters
Liquid propane torches
Hydraulic rock drills
Concrete pumpers
Chain saws
Rakes
Gas leak detection devices
Wire stretchers
Tape measures
Carpenters' squares
Ride-on vacuum cleaners
Brick tongs
Micrometers
Hydraulic boring machines
Hammer drills
Sewer cleaner vactors
Power screwdrivers
Forks
Rotary hammers
Laser guidance equipment for pipe placement
Sewer rodding machines
Walk-behind compacting equipment
Adjustable wrenches
Carpenters' levels
Pickup trucks
Floats
Skid steer loaders
Coring machines
Power sanders
Hydraulic booms
Bench grinders
Punches
Air drills
Demolition saws
Drill presses
Rough terrain forklifts
Asphalt mops
Impact wrenches
Cutout saws
Manlifts
Spades
Cable pullers
Electric boring machines
Air monitoring equipment
Screeds
Belt conveyors
Slings
Laser measuring devices
Oil distributors
Saws
Shielded arc welding tools
Fall arrest systems
Earth tampers
Dump trucks
Power drills
Tripods
Robotic pipe cutters
Vibratory plate compactors
Snowplows
Guniting machines
Mattocks
Swing stages
Salamanders
Loaders
Hydraulic speed shoring equipment
Pressure washers
Pneumatic drills
Plasma cutters
Chip spreaders
Scissor lifts
Post hole augers
Smudge pots
Remote pipe cameras
Sidewalk sweepers
Respirators
Laser levels
Torches
Levels
Stucco spray guns
Gin poles
Concrete mixers
Tuck pointers
Pavement breakers
Caulking guns
Plumb bobs
Protective suits
Hand grinders
Cutoff saws
Dynamite blasters
Road rollers
Water spraying equipment
Circular saws
Water tank trucks
Jig saws
Forklifts
Bandsaws
Asphalt kettles
Scaffolding
Smoke testers
Steam jennies
Picks
Transit levels
Cold chisels
Tappers
Theodolites
Floor saws
Hole cutters
Chipping guns
Bale hooks
Screwdrivers
Paint sprayers
Ladders
Steam cleaning equipment
Kerosene burners
Stump cutters
Water levels
Weed sprayers
Hydraulic track-guided wall saws
Hammers
Electric drills
Hand trucks
Trenchers
Welding hoods
Wagon drills
Scarifiers
Disc grinders
Paddle mixers

Autodesk Revit
Oracle Primavera Enterprise Project Portfolio Management
Microsoft Windows