-
Examine structural timbers and supports to detect decay, and replace timbers as required, using hand tools, nuts, and bolts.
-
Shape or cut materials to specified measurements, using hand tools, machines, or power saws.
-
Construct forms or chutes for pouring concrete.
-
Follow established safety rules and regulations and maintain a safe and clean environment.
-
Select and order lumber or other required materials.
-
Erect scaffolding or ladders for assembling structures above ground level.
-
Verify trueness of structure, using plumb bob and level.
-
Finish surfaces of woodwork or wallboard in houses or buildings, using paint, hand tools, or paneling.
-
Build or repair cabinets, doors, frameworks, floors, or other wooden fixtures used in buildings, using woodworking machines, carpenter's hand tools, or power tools.
-
Measure and mark cutting lines on materials, using a ruler, pencil, chalk, and marking gauge.
-
Perform minor plumbing, welding, or concrete mixing work.
-
Maintain records, document actions, and present written progress reports.
-
Maintain job records and schedule work crew.
-
Install rough door and window frames, subflooring, fixtures, or temporary supports in structures undergoing construction or repair.
-
Work with or remove hazardous material.
-
Bore boltholes in timber, masonry or concrete walls, using power drill.
-
Inspect ceiling or floor tile, wall coverings, siding, glass, or woodwork to detect broken or damaged structures.
-
Arrange for subcontractors to deal with special areas, such as heating or electrical wiring work.
-
Build sleds from logs and timbers for use in hauling camp buildings and machinery through wooded areas.
-
Remove damaged or defective parts or sections of structures and repair or replace, using hand tools.
-
Anchor and brace forms and other structures in place, using nails, bolts, anchor rods, steel cables, planks, wedges, and timbers.
-
Apply shock-absorbing, sound-deadening, or decorative paneling to ceilings or walls.
-
Fill cracks or other defects in plaster or plasterboard and sand patch, using patching plaster, trowel, and sanding tool.
-
Study specifications in blueprints, sketches, or building plans to prepare project layout and determine dimensions and materials required.
-
Install structures or fixtures, such as windows, frames, floorings, trim, or hardware, using carpenters' hand or power tools.
-
Cover subfloors with building paper to keep out moisture and lay hardwood, parquet, or wood-strip-block floors by nailing floors to subfloor or cementing them to mastic or asphalt base.
-
Prepare cost estimates for clients or employers.
-
Assemble and fasten materials to make frameworks or props, using hand tools and wood screws, nails, dowel pins, or glue.
-
Dig or direct digging of post holes and set poles to support structures.